lasercrazy
Flashlight Enthusiast
Looking for a dimmable driver for some quad mods I'm doing. One will be in a 6D mag with alkaline/nimh and the other in a 3C with lithiums. I only need about 3 levels of light but more is ok I guess.
Need suggestions for quad mod drivers.
- Thread starter lasercrazy
- Start date
Help Support Candle Power Flashlight Forum
lasercrazy
Flashlight Enthusiast
65535
Flashlight Enthusiast
The shark driver uses a pot. to control the output, if you could figure out a way to use that adjustabiliy to your advantage then it would be easy, but most solutions result in loss of waterproofness.
lasercrazy
Flashlight Enthusiast
I have yet to figure out an effective way to dim the shark. Anyway I'm looking for a board that can control the levels with just the switch. I don't care if I have to tear the switch apart.
Bikecop
Newly Enlightened
Take a look at the maxflex or fatman boost drivers here:
http://www.taskled.com
George is great about answering e-mails quickly if you have questions about them.
You can mod your switch to make it a momentary contact switch ( I know I saw a thread with pics on how to mod it somewhere on the forums)
http://www.taskled.com
George is great about answering e-mails quickly if you have questions about them.
You can mod your switch to make it a momentary contact switch ( I know I saw a thread with pics on how to mod it somewhere on the forums)
lasercrazy
Flashlight Enthusiast
Looks like what I need is the maxflex but it says not available until october. 
zeeexsixare
Newly Enlightened
- Joined
- Dec 2, 2006
- Messages
- 113
retractedlasercrazy said:Looks like what I need is the maxflex but it says not available until october.
