scottaw
Enlightened
Title sums it up, I'm looking for a reflector to fit 5761 bulbs, cammed or not, doesn't really matter, lookinf for something around MOP --> light stipple. Lemme know what you have.
You can become a Supporting Member.
:candle: Nobody is running this bulb? Come on where are these?!
Everyone is running this lamp. You can just buy a reflector from FM or Litho123 and bore it out to 10.5mm. I recall that my KD SMO had a wide enough opening, but the lamp was just too tall so it wouldn't focus properly. I had Mirage_Man bore out my FM VLOP which works super with the 5761.
Gary
You don't need a 10.5mm hole. 9.5mm is enough (0.37 inch). It's the same diameter as a Surefire MN-series LA pillar.
Greg states that his reflector have 0.377" (9.58mm) openings. I tried three different 5761 lamps in three of his reflectors and none will fit, not even close. There are a few other posts by members who also recommend 10.5mm.
10.5mm will give you extra room, I suppose; but I do sometimes use a 5761 with a Fivemega MN bipin holder in a Surefire KT4 head, so the bulb will actually fit through a 9.5mm hole.
It's easy. A couple minutes with a rolled up piece of wet+dry 320 rotated in the hole. Keep testing with the bulb - it's easy to enlarge it too much. Rinse well with water, rinse with distilled water, then dribble some isopropyl alcohol over it and dab softly with a microfiber cloth.