beam24
Newly Enlightened
- Joined
- Jun 14, 2010
- Messages
- 97
sent u a PM please check :thumbsup:
You can become a Supporting Member.
Whats the turnaround time for the tri-bore service?
Hello Jesus
I am new here, so please be patient with me if i post in the wrong place or do something wrong.
Firstly, Is it possible for you to bore and fin a 4D maglite either Tri or Quad to accept 3 or 4 18650's respectively? I know two will fit side by side easily when bored, but I'd rather have 3 or 4.
If so how much would it cost inc shipping to Brisbane australia (either via USPS or UPS)?
How easy is it to bore yourself at home, and what equipment do you need (i understand if you dont want to answer this though!)? How do you do all the cool finning patterns?
Thankyou very much for your help, much appreciated sir.
Similarly, what would be the situation for this to be repeated for a Maglite 6D?
By the way, in both cases, I don't think i will be using a holder for the batteries, I am just going to stack them in there and mod the tailcap/switch base appropriately.
Jesus,
I'm interested in getting a Mag C bored, and cut down for 26650. I'll supply the tube.
Sending an email now.
Thanks,
Jim
For the 18650 batteries I can only Dual-Bore these. You can not put 3 or 4 side by side. You can only put two side by side.
The top prices are if I get the Mag here and sent it to you.
$25.00 to fin the Mag Head.
Shipping to Australia is around $15.00.
how much to cut down the aa bodys if i supply the tubes?