sherwind2010
Newly Enlightened
- Joined
- May 11, 2015
- Messages
- 30
I put together a little wiring diagram for the XP-G LED's, Now I know it may get hot. But, I only would have it on well I'm driving & only on with the High Beams. I'm going to put ARCTIC MX-4 Thermal Compound on all the LED's, Maybe it with help with cooling, by the way it is the BEST Thermal Compound on the Market, I had some left over from a computer build. It says you do not need to apply it a second time as it will last at least for 8 years.
Here is the Light Bar displaying Voltage & Watts.
I partly opened it up & took a look inside to see what I was working with.
They have these circuits on the board, I don't want any Voltage or Amp limiters & I'm only going to use it on a 12V system. So connected directly to a power source, 4 LED boards wired in series. With that out of the way, Do I need them circuits and\or resistors?
Here is the Light Bar displaying Voltage & Watts.
I partly opened it up & took a look inside to see what I was working with.
They have these circuits on the board, I don't want any Voltage or Amp limiters & I'm only going to use it on a 12V system. So connected directly to a power source, 4 LED boards wired in series. With that out of the way, Do I need them circuits and\or resistors?
Last edited: