Where to find a good spring for positive contact on NANJG 105C 2.8A driver?

[Tana]

I managed to replace burnt driver on my Thrunite XML low mode with famous NANJG 105C from IlluminationSupply... replaced wires as well, made it two mode... ugly as a duckling but WORKS...

However, that small coil is not doing me any good as I do not make contact in Solarforce L2M body...

Anyone have any idea which spring can be used instead of that short coil to be able to make good contact with battery positive? I'm so close to finish my first module (potted as well) but cannot find thin and stiff spring to replace coil for the best of me...

HELP !!! PLEASE !!! Fellow modders !!!

 

[Lampyris noctiluca]

This might work for you: http://www.lighthound.com/HDS-EDC-LED-Flashlight-Spring-ONLY-for-2-x-123-Battery-Case-or-1-x-17670-Battery-Case_p_615.html

Im sure KD and DX sell springs as well.

 

[las3r]

i have a gold-plating spring for high current


Size:9MM(bottom)×6.5MM(neck)×11MM(High)×0.9MM(wire diameter)

Strong Spring for SST50, SST90, P7,MCE ,XM-L T6 High power flashlight

u can have it if u think it will work just send me a pm

 

[Tana]

Thanks guys... especially you las3r... I managed to re-use ThruNite sping by installing it upside down... it's WEIRD looking but I added copper flat on top for better connection with the battery and it's not that bad at all... It WORKS...

 

[Justin Case]

This might work for you: http://www.lighthound.com/HDS-EDC-LED-Flashlight-Spring-ONLY-for-2-x-123-Battery-Case-or-1-x-17670-Battery-Case_p_615.html

Im sure KD and DX sell springs as well.

You have to be careful with a spring like that. The length vs diameter ratio looks to be close to borderline in terms of buckling stability.

 

[las3r]

not a problem im glad it worked out for u

if u still need it just let me no, this is a stiff spring and should not have any problem on buckling