Disregard
Terms:
ArcLS First Run #726 Triple Nichia 219 (modded by datiLED) Withdrawn
I don't want to let this one go but something has just come up and funds are needed. From datiLED:
Terms:
- I ship First Class at no additional charge, Priority Mail Flat Rate Small Box upgrade is available for an additional $2.50 unless otherwise noted
- Will ship International with a traceable service at buyers cost - PM your Country or Postal Code for quote and more information
- USPS Money Order or Paypal Purchase of Goods Option (no gift payments please)
- Paypal payment must be received within 12hrs unless previously discussed
- "I'll take it", either in the thread or by PM, gets it
- Open to trades
ArcLS First Run #726 Triple Nichia 219 (modded by datiLED) Withdrawn
I don't want to let this one go but something has just come up and funds are needed. From datiLED:
The Arc triple has three Nichia 219 LEDs in parallel, driven by an AMC 3-level regulator board. The optic is a Carlco 10507 narrow array. The heatsink is a solid piece of turned aluminum that contacts the inside of the head for good heat dissipation.
Using a quality 750mAh RCR cell, 70mA should give at least 11 hours of runtime, 420mA should give at least 90 minutes of runtime, and 1400mA should give a little more than 20 minutes. This is based on cell capacity and current drain, with some fudge factor applied. I think that the light would get pretty hot after 20 minutes on high. The heatsink is massive, but the light is small. That is a lot of heat to dissipate. I only tested the high level for 10 minutes, or so. It got warm, but I was holding the light with a full hand grip.
The light can use any RCR cell, and IMR's are recommended. The levels are set at 70mA, 420mA and 1400mA. (5, 30 and 100%) BTW, it is the 1400mA driver board from Illumination Supply.
Last edited: