What I really don't understand is what works or how to figure what works in different applications. For example what is a buck convertor? and do i need one? Sorry for the questions, but I honestly dont understand but really want to learn. This is what keeps my interest up in stuff like this.
I've been playing with hotwires and drop in's for a while now, but would like to do something from scratch. What I want to to is something along the lines of a 2 or 3 x lithium setup on a sst-50 in a mag 4c host. What I do not understand or have any grasp of at all is the driver/circuit board...
I have a hobby charger on the way and have been reading up on setting up for balance charging. After looking through the threads on trying to solder to magnets and the difficulty with it I thought why not use a thin alligator clip on magnet and no need to solder. Will this work?
Re: how to polish a MAG bezel
I tried this the other day to attempt my first at home anodizing. Anodizing did not go well but was able to polish entire light. I used draino first, then went to a belt sander. I sharpen knives on it so I have belts all the way up to 9 micron as well as a leather...
I sent the original message to Lux, and i believe it is a battery issue at this point. I'm using old tenergy 2600's, so I'm going to get new batts. But know you have me thinking, will I see as much output if I go the lithium route? I was thinking of using 3 26650's or 26500's, and how would I...
This is a littel off topic but has to do with the 139 charger and AW18650 batts. i just received the batteries and Ultrafire 139 couple days ago . Charged up 2 16340's no problem, put the 18650's in and it was working fine on the right side compartment (light was red and occasionally flashing...
I just found this and it looks like to me what I need http://kaidomain.com/ProductDetails.aspx?ProductId=1770
Thanks for being patient and helping, it seems like the more I read the more confused I get. But its fun learning this suff and experimenting
Thanks for the reply Dave and everyone else, I'll try one of DX's convertors and hope for the best. Hopefully this helps the OP before he runs into any problems like I have.
Dave, is it possible for you to post a link to what your using. Thanks.
Dont mean to hijack this thread but I have a question that relates. I have a 3 d mag with a P7 running direct drive. At first i ran on 3 d alkalines and everything looked good. Swithed to 3D Tenergy NiMh's and it looks good for about 20 seconds then LED starts turning blue. I'm new to all this...