Black Arc LS Cree XM-L Tri-FLuPIC Mod

darkzero

Flashaholic* ,
Joined
Oct 7, 2003
Messages
4,459
Location
SoCal
Hope the owner enjoys! :wave:

-Black Anodized Arc LS
-Cree XM-L T6
-Tri-FLuPIC v2.2 3P 2.5A
-Custom AL Heatsink
-Modified 18mm Reflector
-Mineral Glass Lens
-Glow Oring



Img_2389.jpg


Img_2364.jpg


IMG_2406.jpg


Img_2396.jpg




Making the heatsink.
Img_1429.jpg




Drilling a couple of holes.
Img_1593.jpg


Img_1451.jpg




MCPCB turned down to match the base of the reflector.
Img_1809.jpg




Heatsink tapered to match the reflector for centering.
Img_2343.jpg


Img_2349.jpg




Shortened reflector.
Img_2336.jpg




Tr-FLuPIC wired in 3 parallel.
Img_1789-1.jpg




Completed module.
Img_2357.jpg




Tailcap bored deeper to minimize the gap between body & tail due to the increased stack height.
Img_1687.jpg
 
Beamshot comparison (not necessrily depicting it's true brightness) against my Arc LS P7 Tri-FLuPIC mod. Same driver as used in this one. Puts my P7 Arc to shame with a better tint & nicer beam.

Left: XM-L T-6, Right: P7 CSXOI
ArcLS_XM-L_T6_CSXOI.jpg



And a group shot of the two sterile bodied big boys.
Img_2417.jpg
 
Last edited:
It is a bang-up job in the height 😱
It is beautiful highest.
I want to meet early 😛

The highest thanks
 
Thanks everyone! :wave:

Beamshot added to the second post.

Must be a love job as your sig says your still retired... 😉

It was a special one that was long over due. Since I wanted to buy this host at one time, when I was asked to give it life quite some time ago I agreed.


Please, come out of retirement!

your signature doesn't reflect your current mood (mod)

I'm still "retired" but even retired people work. Still thinking about it. After all, this is not the first time. :sssh:


Where did you get those glow Orings?

IIRC I purchased my glorings from Sigman years ago. Not sure if he still sells them, haven't been to the MP in a very long time.


It is a bang-up job in the height 😱
It is beautiful highest.
I want to meet early 😛

The highest thanks

You are most welcome & thank you! It will finally be home soon.
 
Last edited:
Back
Top