See this is the problem, my 4 chuck is set up so I can slap it on the lathe and within 5 minutes I am ready to cut on the D sized
M@gs. Going to C sized would make me set everything up again twice.....unless I marked two of the jaws with the D sized settings then the C sized setting. Great idea Brian!!
Currently I have tape on the two jaws that I don't mess with (much), so I just tape the same way everytime, slap it in tighten down two jaws..done. Either that or it's time to really set up the lathe properly or get that new Bison 6 jaw I was looking at.....
Bob E.