The_bad_Frag
Enlightened
Hey there! :wave:
After a long time I did some modding again! I modded my Led Lenser P3 a while ago with a new driver and a XP-G. But I never was completely happy with it. So it was time to revisit it. Here is the old thread.
Now I made a custom head for it, changed the position of the driver and switched the aspheric to a reflector. Also I put a UCL lens in. The clip on it is from my Fenix LD01. It draws about 2A at the tail and throws quite well for its size.
Parts:
LED Lenser P3
3-Mode Regulated Circuit Board (shiningbeam)
CREE XP-G R5 on 16mm star
20mm UCL lens
Ledil Regina Reflektor 10°
Cables, some plastic, and other usual stuff...
After a long time I did some modding again! I modded my Led Lenser P3 a while ago with a new driver and a XP-G. But I never was completely happy with it. So it was time to revisit it. Here is the old thread.
Now I made a custom head for it, changed the position of the driver and switched the aspheric to a reflector. Also I put a UCL lens in. The clip on it is from my Fenix LD01. It draws about 2A at the tail and throws quite well for its size.
Parts:
LED Lenser P3
3-Mode Regulated Circuit Board (shiningbeam)
CREE XP-G R5 on 16mm star
20mm UCL lens
Ledil Regina Reflektor 10°
Cables, some plastic, and other usual stuff...
Last edited:
