axd
Newly Enlightened
Recently bought a LF2XT (thx Ku - waiting for the 3H!), love the puzzle.
Then I programmed following FUI config (5 modes): lo-slow beacon-strobe-random strobe-SOS
Days later, still playing with the light, I wanted to change mode 2 to double flash beacon.
When entering programming mode (3C+PH), I could not switch to frequency adjust (4C) - was stuck in brightness adjust.
The light would keep single flash with est. 0.5 sec spacing, unable to change the frequency of the strobe; brt was fine.
Was also unable to change type (PH): this mode was stuck in beacon.
Finally, did a factory reset and now was able to reprogram, then modify as desired.
Strange.
Then I programmed following FUI config (5 modes): lo-slow beacon-strobe-random strobe-SOS
Days later, still playing with the light, I wanted to change mode 2 to double flash beacon.
When entering programming mode (3C+PH), I could not switch to frequency adjust (4C) - was stuck in brightness adjust.
The light would keep single flash with est. 0.5 sec spacing, unable to change the frequency of the strobe; brt was fine.
Was also unable to change type (PH): this mode was stuck in beacon.
Finally, did a factory reset and now was able to reprogram, then modify as desired.
Strange.