Lumens Factory HO-E2A

[batman]

I have really been impressed with Lumens factory in the past, but I am very upset witth this latest lamp assembly. I ordered 2 HO-E2As for my E2E to find one was DOA and both of them are too large. When screwing down the bezel with the Lumens factory lamp installed, it won't go down all the way like it would with the MN02. There is about a 1 mm gap in the threads which I think would let all kinds of dust and water in where I work. Does anyone else have this problem with Lumens Factory E-series lamp assemblies in their E2/ E1s?

 

[willrx]

I don't have this problem, but LF stands by their products. Send them an email. I'm sure they'll help.

 

[curtispdx]

I just received a DOA HO bulb for my A2. A replacement is enroute but I still have to send the defective one back. (That kind of sucks.)

 

[bestcounsel]

I had the problem with an H0-E2A not fitting in one of my e2e's before....i also had a LF 9volt battery die out on me in one day....

 

[ishmael]

I hadn't noticed it until I looked just now and yes I have a larger gap between the bezel and the body but it still seems to be in full contact with the o ring. I haven't measured but it could be my batteries too, I have BS rcr 123s, don't know if they are longer than the primaries or not.