maglite 3d mod basic questions

[bosch040]

Helle there,

I'm new here and trying to mod my first maglite 3d.
My english is not that good, i'm sorry.

I would like to ask you if i can use the folowing parts toghetter:

LED:
Cree XM-L T6 LED
* 3V typical driving voltage
* 280 lumen at 700mA
* Up to 975 lumens at 3A

http://www.shiningbeam.com/servlet/the-253/**NEW**-Cree-XM-dsh-L-T6/Detail

Driver
3-Mode Regulated Circuit Board for XML

* Regulated circuit board designed for Cree XML, MC-E, SSC P7 and SST-50
* 3 modes: Low>Med>High
* Voltage input: 2.8V - 6V
* The memory feature will memorize the last mode
* Output current: 140mA on low, 1,000mA on med, and 2,800mA on high
* 17mm base board diameter
* Lead wires already soldered on the board
* Reverse-polarity protection prevents wrongly installed batteries from damaging the circuit

http://www.shiningbeam.com/servlet/the-132/3-dsh-Mode-Regulated-Circuit-Board/Detail

Batteries

4 x c size 1.2v 4400mAh (total of 4,8v)

thx rene

 

[PCC]

Yes, you can. I just started a very similar build last night and should have it done tonight or tomorrow night.

 

[bosch040]

Cool, thx! I'm curious how things work out for you mod.
I'm gonna order the parts tonight! Hope they'll arive sone! From New York to the Netherlands :laughing: