Nitcore D10 clip vs. EX10 clip - same size?

[Closet_Flashaholic]

So,
I noticed that there are two different p/n for a clip for a D10 vs. an EX10. Is the EX10 just shorter - or is the intended diameter of the mount different?

Anyone have both that could post a side-by-side pic? Or describe the differences?

(I have a different project in mind, which is why I am wondering)

Thanks.

 

[deranged_coder]

The D10 and EX10 have different diameter bodies, so the clips also have different diameters.

You can try looking for some pics in this thread:

*** The Nitecore D10 / EX10 Photo Thread!! ***

Edit: This question came up before, in the thread that I linked. My reply, along with accompanying photo is here: http://www.candlepowerforums.com/vb/showpost.php?p=2794977&postcount=211

 

[Closet_Flashaholic]

Thanks. I did find what I was looking for, sort of. None of the pics showed them tail standing side-by-side so I could only estimate the lengths, which look to be the same, just the diameter is different.

 

[RocketTomato]

I think the actual clip is the same on both models and the only difference is in the backside plate. I am not 100% certain however.

 

[tsmith35]

I think the actual clip is the same on both models and the only difference is in the backside plate. I am not 100% certain however.

I got one of each and they appeared identical. Held them up side-by-side and couldn't see a difference. Perhaps they started out different, but it was cheaper to just make the identical at some point.

One of the back plates had a hole that seemed to be stripped (wouldn't tighten). Put that end of the plate on a vise and held it down with a round punch slightly larger than the hole and gave the punch a couple taps with a hammer. Problem solved.

 

[Marduke]

I think the actual clip is the same on both models and the only difference is in the backside plate. I am not 100% certain however.

That is correct.

The clips are identical, the backer plates are different.