Replacing a ITP SA2 eluma boot

[SMC527]

Can someone intsrcut me on how to replace a boot on a ITP SA2 eluma? Also...where to get additional spare boots would be good information to have as well


thanks


Stephan

 

[PerttiK]

If it is the tail switch boot you're talking about, just screw open the switch holder inside the tailcap.
Use some small nose pliers or cirlclip pliers in the 2 holes you see in the switch holder.
Then take out the washer and the boot.

The boot seems to be a bit odd size, 13 or something mm.

But, these from shiningbeam fit:
http://www.shiningbeam.com/servlet/the-17/Assorted-Color-Silicone-Tailcaps/Detail

You need to trim down the knob inside the boot.

Also, reverse switch and boot should come with the light.

 

[SMC527]

the reverse switch came, but not an additional boot....


thanks for the info!

 

[PerttiK]

I just looked in the package my light came in, and in one plastic bag should be 2 boots and 2 o-rings.
If I remember correctly, all these extra parts were inside the holster.