Turning-Down NX-05 Optics

[this_is_nascar]

I need to turn-down an existing NX-05 to make it smaller in both diameter and length. I have a Dremel, but am unsure with adapter would be best suited for the cleanest "cut" possible. Should I use the sandpaper wheel, grinding stone wheel, etc?

 

[onelight]

Nascar I read a post recently that spoke of sawing the Nxo5 to length and repolishing with progressive grits of sand paper.That is the only detail I recall, Sounds like a lot of work. good luck /ubbthreads/images/graemlins/popcorn.gif

 

[Chief_Wiggum]

I can't remember the thread either, but I'm pretty sure it was the Fraen that was used.

Basically, the face of optic was sanded on a belt sander until the desired height was reached. Then it was finished with two very flat mill files. Finally polished. It looked fantastic.

 

[jdriller]

I think Slick is the master on this one.

 

[onelight]

the shape of the optics would seem to make this tough to do and keep the face square to the bezel. /ubbthreads/images/graemlins/smile.gif

 

[Rothrandir]

well if you've got a lathe, it's an easy job... /ubbthreads/images/graemlins/tongue.gif

i've heard of people attaching the optic to a thin dowel, then turning it agains a beltsander... /ubbthreads/images/graemlins/icon3.gif

 

[CiTY]

Here it is:

http://www.candlepowerforums.com/ubbthreads/showflat.php?Cat=&Board=UBB14&Number=350150&page=1&view=collapsed&sb=5&o=&fpart=1

 

[this_is_nascar]

Thanks everyone.