Will this work for fenix

[tricker]

will these batteries work on a p1d premium q5
https://www.all-battery.com/index.asp?PageAction=VIEWPROD&ProdID=1877

 

[Albinoni]

The link you attached said the voltage of those batts were 3.0 volts, as far as I know rechargeable CR123A's i.e RCR123A's are actually 3.6 volts. You have to make sure the P1D and mainly its LED will accept or take 3.6 volts or you might blow the LED.

Ok just did some research and saw this light on Ebay, so yes you can use it as it will take 1.5 - 4 volts, so should be ok.

Also just make sure the quality of those batts are ok, last thing you want is some cheap batt exploding in your torch :mecry:

 

[Mr Happy]

will these batteries work on a p1d premium q5
https://www.all-battery.com/index.asp?PageAction=VIEWPROD&ProdID=1877

In case you have not already seen it, Probedude in this thread reviews the very set you linked to. Apparently the quality of the cells is a bit variable, and you should not expect to get the 750 mAh claimed for them.

But apart from that these cells are 3.2 V LiFePO4 and as I understand it they should work in the P1D without loss of any modes.

 

[jenskh]

The specification says max discharge rate <550 mA.
According to my measurements, My Fenix P1D CE Q5 draws about 1,7 A from a 3.0 V Tenergy battery (not LiFePO4) in turbo mode. This means that the LiFePO4 you should probably not be used for this mode.

The 3.0 V Tenergy battery batteries I use works quite well and gives the desired differences between the modes, but the protection kicks in from time to time in turbo mode. It is just to turn the light off and on again and it works.