i am modding a Makita worklight to 2x Cree X RE serial.
- Emitters
- Optics
- 5 mode Driver by the way: got a better suggestion?
What surface temperature is acceptable on the plate (5mm aluminum) with the emitters on it?
i reach 80°C (176°F)after 25 minutes on high (approx. 800mA on both emitters).
- Emitters
- Optics
- 5 mode Driver by the way: got a better suggestion?
What surface temperature is acceptable on the plate (5mm aluminum) with the emitters on it?
i reach 80°C (176°F)after 25 minutes on high (approx. 800mA on both emitters).
