Groundhog66
Banned
Anyone have any of these available, I would be interested in multiples.
Tim
Tim
-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
Sold/Expired WTB - "Moses" board for Arc First Runs
- Thread starter Groundhog66
- Start date
Help Support Candle Power Flashlight Forum
Groundhog66
Banned
Groundhog66
Banned
I have to believe there are some out there that COULD come available.
Bullzeyebill
Flashaholic
Somebody please bring me up to speed re "Moses" board. What circuit did (does) he use? Seem to recall references to Moses' work a few years ago.
Bill
Did a search, and now I remember. Two stage switch for LS1. The LS1 uses a constant current circuit device? The predecessor to the LSH?
Bill
Bill
Did a search, and now I remember. Two stage switch for LS1. The LS1 uses a constant current circuit device? The predecessor to the LSH?
Bill
Last edited:
Hi, check out this thread of mine with some
research I had done on these boards from Moses.
In short:
- Aftermarket board made by Moses, probably Pierce-technilogy
- Only for First Runs (Not LS1, LS2, LS3, LS-HS, etc...)
- Donut-shaped Circuit-board glued on metal heatsink
- Regulated, about 80% efficient,
- Switchable drive current 200mA or 400mA
The above thread has way more info, close-ups of different angles,
even the schematics and how to change drive-current.
(Bill, you even posted there too...
)
Cheers !
research I had done on these boards from Moses.
In short:
- Aftermarket board made by Moses, probably Pierce-technilogy
- Only for First Runs (Not LS1, LS2, LS3, LS-HS, etc...)
- Donut-shaped Circuit-board glued on metal heatsink
- Regulated, about 80% efficient,
- Switchable drive current 200mA or 400mA
The above thread has way more info, close-ups of different angles,
even the schematics and how to change drive-current.
(Bill, you even posted there too...
)Cheers !
