RobertMM
Flashlight Enthusiast
Hi all.
I managed to source a few XP-G2 on copper sinkpads for a mod, and have some left over.
Would these work fine on a fresh CR123A direct drive, with absolutely nothing to control current or voltage?
Datasheet says 2.8-3.1volts.
Any idea what kind of current the LED may see with this setup? I'm curious with runtime as well.
What I'm planning is to build a moderate/low power dropin to use in a G2 with a dummy CR123. Or maybe two AAs in a G3.
I managed to source a few XP-G2 on copper sinkpads for a mod, and have some left over.
Would these work fine on a fresh CR123A direct drive, with absolutely nothing to control current or voltage?
Datasheet says 2.8-3.1volts.
Any idea what kind of current the LED may see with this setup? I'm curious with runtime as well.
What I'm planning is to build a moderate/low power dropin to use in a G2 with a dummy CR123. Or maybe two AAs in a G3.