JohnRussell
Newly Enlightened
Hello,
I recently bought about 60 led fixtures to install in the risers on some deck stairs. These were purchased in three different batches because I was trying to sort out how many I needed to get adequate stair coverage. These fixtures are in a small 3/4" or so diameter "cup" that has three leds and a small circuit board with resistor. The majority of the fixtures are filled to the very top of the "cup" with expoxy, but about 20 or so of these are not filled completely and the leds are exposed, but the circuit boards appear to be covered. I think this is probably just fine, but does anyone see a problem with the emitters being exposed?
I recently bought about 60 led fixtures to install in the risers on some deck stairs. These were purchased in three different batches because I was trying to sort out how many I needed to get adequate stair coverage. These fixtures are in a small 3/4" or so diameter "cup" that has three leds and a small circuit board with resistor. The majority of the fixtures are filled to the very top of the "cup" with expoxy, but about 20 or so of these are not filled completely and the leds are exposed, but the circuit boards appear to be covered. I think this is probably just fine, but does anyone see a problem with the emitters being exposed?
