emmanhello
Newly Enlightened
HI!
I've got 4x ''3w'' leds (not really 3w) ripped from cheap MXDL flashlights. I wanted to make a headlight for my RC.
So, led need 3.4v at 300-400ma, I connected 4 in parallel and the ouput of my RC's ESC is 5v. How do I regulated voltage and current?
I'm still a bit confused about how led driver works. Does this one could fit?
Would that be simpler with a resistor or would they burn if they were plugged directly to the 5v output?
Thanks!
I've got 4x ''3w'' leds (not really 3w) ripped from cheap MXDL flashlights. I wanted to make a headlight for my RC.
So, led need 3.4v at 300-400ma, I connected 4 in parallel and the ouput of my RC's ESC is 5v. How do I regulated voltage and current?
I'm still a bit confused about how led driver works. Does this one could fit?
Would that be simpler with a resistor or would they burn if they were plugged directly to the 5v output?
Thanks!
Last edited: