By mistake I connected the trustfire TR-3T6 driver to 3*XML wired in series. Battery configuration : 3×18650 in series.
This is a 4,8A driver and was designed to run 3 leds wired in parallel at a maximum of 1,6A for every led.
Luckily I quickly realized the mistake and powered off the flashlight after ~10 seconds or so.
The question is what voltage and the amperage was the driver forced to deliver? Did I compromise the leds or the driver itself ?
Thank you.
This is a 4,8A driver and was designed to run 3 leds wired in parallel at a maximum of 1,6A for every led.
Luckily I quickly realized the mistake and powered off the flashlight after ~10 seconds or so.
The question is what voltage and the amperage was the driver forced to deliver? Did I compromise the leds or the driver itself ?
Thank you.