Flatshovel
Newly Enlightened
- Joined
- May 3, 2008
- Messages
- 24
Ok, I have a question. I have a BC-900 charger that I was charging up some 2400mah lsd Imedions on today. I think the charger is not terminating correctly and wanted to get the thoughts and opinions from this forum. When I started the cell voltage was 1.16 I set the charger to charge at 1500mah which is just a hair above 0.5c rate, the cell voltage got to 1.54v and display was reading 2.2ah and was still charging. The batteries never got hot just warm at charging at this rate. I only charged up 2 AA batts in slots 1 & 4. I stopped the charging when the capacity hit 2.2ah not wanting to overcharge them. I thought battery voltage when full would show about 1.46-1.47v. Since the voltage went up to 1.54 did the charger miss the signal? Just wondering?
Thanks,
Joey
Thanks,
Joey