aurum
Enlightened
Hi ...
Just another 9 Amps driver Thread ... Some prototyping is already done :naughty:
The specs/facts:
- Output Current: 0-9A
- Min. Input Voltage: 5V
- Max. Input Voltage: 20V (up to 12,6V recommended)
- Diameter: 33mm
- Height: about 10-15mm
- Efficiency up to 92%
- driver needs to be heatsinked
Single mode driver respectively you could solder two wires to the pads and connect a potentiometer to it. By pressing the Mag switch the driver will start with the current adjusted by pot.
Some pictures ...
cheers
aurum
Just another 9 Amps driver Thread ... Some prototyping is already done :naughty:
The specs/facts:
- Output Current: 0-9A
- Min. Input Voltage: 5V
- Max. Input Voltage: 20V (up to 12,6V recommended)
- Diameter: 33mm
- Height: about 10-15mm
- Efficiency up to 92%
- driver needs to be heatsinked
Single mode driver respectively you could solder two wires to the pads and connect a potentiometer to it. By pressing the Mag switch the driver will start with the current adjusted by pot.
Some pictures ...
cheers
aurum