I have a couple of motion activated outdoor lights that have two Bridgelux BXRA-56C1000-A LED modules. The original circuit boards in the bases were not protected against weather. The motion sensors are a separate device that connects to AC and switched power to the LED circuit.
Space in the metal base is about 4.3" diameter by 1.5" deep.
Datasheet on the modules https://www.bridgelux.com/sites/def.../DS23-Bridgelux-ES-Star-Array-Data-Sheet1.pdf
All ratings at Tj = 25ºC except where noted.
Part Number, CCT & CRI, Current, Voltage, Power, Flux, Flux Tcase = 85ºC, Efficacy
BXRA-56C1000-A-xx, 5600K 70 CRI, 115, 25.3, 2.9, 395, 340, 136
BXRA-56C1000-A-xx, 5600K 70 CRI, 250, 26.5, 6.6, 850, 735, 128
BXRA-56C1000-A-xx, 5600K 70 CRI, 350, 27.3, 9.6, 1150, 1000, 120, <-Recommended use
BXRA-56C1000-A-xx, 5600K 70 CRI, 500, 28.4, 14.2, 1580, 1375, 111
The lights had no heat sink compound under the modules, completely bare against the interior of die cast housings. So I put some on, same non-coductive stuff I use on CPUs.
I happen to have two places ideal for these, front of my shop and under the roof by the back house door.
Space in the metal base is about 4.3" diameter by 1.5" deep.
Datasheet on the modules https://www.bridgelux.com/sites/def.../DS23-Bridgelux-ES-Star-Array-Data-Sheet1.pdf
All ratings at Tj = 25ºC except where noted.
Part Number, CCT & CRI, Current, Voltage, Power, Flux, Flux Tcase = 85ºC, Efficacy
BXRA-56C1000-A-xx, 5600K 70 CRI, 115, 25.3, 2.9, 395, 340, 136
BXRA-56C1000-A-xx, 5600K 70 CRI, 250, 26.5, 6.6, 850, 735, 128
BXRA-56C1000-A-xx, 5600K 70 CRI, 350, 27.3, 9.6, 1150, 1000, 120, <-Recommended use
BXRA-56C1000-A-xx, 5600K 70 CRI, 500, 28.4, 14.2, 1580, 1375, 111
The lights had no heat sink compound under the modules, completely bare against the interior of die cast housings. So I put some on, same non-coductive stuff I use on CPUs.
I happen to have two places ideal for these, front of my shop and under the roof by the back house door.