Building my first dive light with a mag lite and a 5*Cree deal extreme drop in.
I have installed the led but would like to update the driver as I have read on this forum that it is not taking full advantage of the led's capacity..
I found a post on here some time ago about how to modify the driver but that looked a little complicated so I was going to purchase and install a taskled driver.
My question is... which driver from taskled to I need ??? I believe I understand that each led is driven by 3.4v (?) which would be a total of 17volts but since I am using a 7.4v li-ion 2s pack I would need a "boost" driver and not a "buck" driver (if only powering a single led )????
Also, is there a driver from taskled that doesnt have multimode capability, as I dont think I would need that for this application?
Eric
I have installed the led but would like to update the driver as I have read on this forum that it is not taking full advantage of the led's capacity..
I found a post on here some time ago about how to modify the driver but that looked a little complicated so I was going to purchase and install a taskled driver.
My question is... which driver from taskled to I need ??? I believe I understand that each led is driven by 3.4v (?) which would be a total of 17volts but since I am using a 7.4v li-ion 2s pack I would need a "boost" driver and not a "buck" driver (if only powering a single led )????
Also, is there a driver from taskled that doesnt have multimode capability, as I dont think I would need that for this application?
Eric