CLOSED
These Fenix 1AA bodies were just gathering dust so I thought something
should be done
They were bored out partially to accept 3V CR2 batteries.
You will need to use the Delrin spacer to bridge the gap.
You can always switch back to easily available AAs.
- A: Fenix L1P Body bored out to accept CR2.
- B: Fenix L1P Body bored out to accept CR2.
A and B are bodies from the first run of the L1P. Note that they have
the thinner O-rings.
The finish is a rather dull grey compared to the ano on more recent Fenix lights.
- C: Fenix L1T body bored out to accept CR2.
C was made from a L1T AA body and has longer, bare aluminum threads on the bezel side.
Yes, the 2 stage will work on a L1T/L2T bezel. It works with a L2P bezel as well.
All come with a Delrin spacer.
$US15 each shipped anywhere. Paypal only (any kind).
An unconditional posted here has priority.
Please state which body A/B/C you want. I will send you a PM with payment details.
*************
I do not recommend using these with the L1P bezel which has a circuit board designed for 1.5V.
Some people have been using them at 3V or in some cases 3.7V setups, but this may reduce
the LED's lifespan drastically, or just blow it.
I will not be held responsible for any damage to your light.
Use at your own risk.
Batteries not included.
These bodies were used for measuring and fitting custom parts. You may notice some wear
on the threads, but they are all uncarried. Any nicks or scratches are the way they came.
Grease has been wiped off so please lube before using.
I'm not sure if they are wide enough to use a RCR2 since I don't have none :shrug:
Thanks for looking :wave:
These Fenix 1AA bodies were just gathering dust so I thought something
should be done
They were bored out partially to accept 3V CR2 batteries.
You will need to use the Delrin spacer to bridge the gap.
You can always switch back to easily available AAs.
- A: Fenix L1P Body bored out to accept CR2.
- B: Fenix L1P Body bored out to accept CR2.
A and B are bodies from the first run of the L1P. Note that they have
the thinner O-rings.
The finish is a rather dull grey compared to the ano on more recent Fenix lights.
- C: Fenix L1T body bored out to accept CR2.
C was made from a L1T AA body and has longer, bare aluminum threads on the bezel side.
Yes, the 2 stage will work on a L1T/L2T bezel. It works with a L2P bezel as well.
All come with a Delrin spacer.
$US15 each shipped anywhere. Paypal only (any kind).
An unconditional posted here has priority.
Please state which body A/B/C you want. I will send you a PM with payment details.
*************
I do not recommend using these with the L1P bezel which has a circuit board designed for 1.5V.
Some people have been using them at 3V or in some cases 3.7V setups, but this may reduce
the LED's lifespan drastically, or just blow it.
I will not be held responsible for any damage to your light.
Use at your own risk.
Batteries not included.
These bodies were used for measuring and fitting custom parts. You may notice some wear
on the threads, but they are all uncarried. Any nicks or scratches are the way they came.
Grease has been wiped off so please lube before using.
I'm not sure if they are wide enough to use a RCR2 since I don't have none :shrug:
Thanks for looking :wave:
Last edited: