Robocop
Moderator, *Mammoth Killer*
I can not find the old thread on this in a search.
I am trying to remove the reflector without damaging the bezel however have had to use a Dremel on every one so far.
I read somewhere that some have been able to actually push the reflector out the front without damage.
This seems impossible on all of my samples as they will not move at all.
Is it possible to heat one in boiling water or some other trick?
I am trying to put an NX-05 in the original bezel after I cut it down a little in order to work better with my luxeon mod I have done to the original board.
I have to keep the bezel intact for this to work and all I have tried has failed...any ideas?
I am trying to remove the reflector without damaging the bezel however have had to use a Dremel on every one so far.
I read somewhere that some have been able to actually push the reflector out the front without damage.
This seems impossible on all of my samples as they will not move at all.
Is it possible to heat one in boiling water or some other trick?
I am trying to put an NX-05 in the original bezel after I cut it down a little in order to work better with my luxeon mod I have done to the original board.
I have to keep the bezel intact for this to work and all I have tried has failed...any ideas?