Ok guys it's time for me to sell this light... It's going because it never gets any real use... I have run it maybe 4 times till fully discharged =/ ...
Let's start with the light description:
-Natural HA C3 Centurion bored to accomodate 18650 cells (I used LG 2600mah with no problems)
-MC123-HA cell extender (Anodizing matches closely but not perfectly)
-KT2 turbohead in matching HA (matches pretty much identically) -- SOLD
-Brand new, never even opened breakaway lanyard that was included with light (from my other SF)
Included Surefire LA's
-P90 (105L) few cycles
-P91 (200L) one cycle
-MN16 (225L) just tested -- SOLD
-MN21 (500L) one or two cycles
Other
-SC2 Carrier (Holds 6 cr123's and shock isolated LA, ie MN21 etc)
Does not include lanyard, does include 6 batterystation cr123's -- SOLD
Condition
-The light is pretty much mint, it has a light knick near the clip that isn't noticeable unless you look for it
-When the light was bored first the body was bored and then the extender, not together. Because of this to insert batteries you need to do so from either the top or at the extender, not after at the switch.
Pictures
and most recently compared to my 2 1/3D mag
I spent roughly $400 on all of it plus shipping... looking for $310 paypaled for the whole setup shipped in the continental US, insured with delivery confirmation.
Let's start with the light description:
-Natural HA C3 Centurion bored to accomodate 18650 cells (I used LG 2600mah with no problems)
-MC123-HA cell extender (Anodizing matches closely but not perfectly)
-KT2 turbohead in matching HA (matches pretty much identically) -- SOLD
-Brand new, never even opened breakaway lanyard that was included with light (from my other SF)
Included Surefire LA's
-P90 (105L) few cycles
-P91 (200L) one cycle
-MN16 (225L) just tested -- SOLD
-MN21 (500L) one or two cycles
Other
-SC2 Carrier (Holds 6 cr123's and shock isolated LA, ie MN21 etc)
Does not include lanyard, does include 6 batterystation cr123's -- SOLD
Condition
-The light is pretty much mint, it has a light knick near the clip that isn't noticeable unless you look for it
-When the light was bored first the body was bored and then the extender, not together. Because of this to insert batteries you need to do so from either the top or at the extender, not after at the switch.
Pictures
and most recently compared to my 2 1/3D mag
I spent roughly $400 on all of it plus shipping... looking for $310 paypaled for the whole setup shipped in the continental US, insured with delivery confirmation.
Last edited:
