Ok, I have a lot of lights with many different UIs, and can work each of them just fine. Programming the Novatac 120P..no problem. I can read instructions.
However, when I received my first LiteFlux LF3 and couldn't get it to work after many attempts and thoroughly reading the manual, I was positive it was a malfunctioning light. LED Cool had me clean some contacts and check the switch spring, but with no luck so he sent me out a new one.
3 weeks later, and I get the new light - same problem!!
When I turn the light on to position 1, it flashes 3 times slowly, stays lit on a low level, when I turn it to position 2, it comes on high for a couple of seconds, then strobes for about 10 seconds and then just shuts off. If I try switching modes (P2 -> P1 -> P2) while it's doing this - no effect. Any time I try switching modes it starts this same routine: slow flash->strobe->off.
Both lights seemed to work the first time I turned them on for about 30 seconds of solid light, but as soon as I tried switching modes they went into this flash/strobe/off mode and I can't do anything to change it! It is driving me crazy...
I have tried multiple primary CR123s - Surefires and Duracell Ultras. I've even checked them on a multi-meter to make sure they are fresh. Is this light only meant to work with RCRs (3.7v)?? I don't have any to test it with unfortunately.
PLEASE HELP!!!!!!! (can you tell I'm more than a little frustrated?...........):sigh:
However, when I received my first LiteFlux LF3 and couldn't get it to work after many attempts and thoroughly reading the manual, I was positive it was a malfunctioning light. LED Cool had me clean some contacts and check the switch spring, but with no luck so he sent me out a new one.
3 weeks later, and I get the new light - same problem!!
When I turn the light on to position 1, it flashes 3 times slowly, stays lit on a low level, when I turn it to position 2, it comes on high for a couple of seconds, then strobes for about 10 seconds and then just shuts off. If I try switching modes (P2 -> P1 -> P2) while it's doing this - no effect. Any time I try switching modes it starts this same routine: slow flash->strobe->off.
Both lights seemed to work the first time I turned them on for about 30 seconds of solid light, but as soon as I tried switching modes they went into this flash/strobe/off mode and I can't do anything to change it! It is driving me crazy...
I have tried multiple primary CR123s - Surefires and Duracell Ultras. I've even checked them on a multi-meter to make sure they are fresh. Is this light only meant to work with RCRs (3.7v)?? I don't have any to test it with unfortunately.
PLEASE HELP!!!!!!! (can you tell I'm more than a little frustrated?...........):sigh:
Last edited: