Inova T4 LED swap, if possible

[superjoe83]

i have the reflector version of the T4 and have an extra Cree xe-r that was left over from another project that if possible will swap them, Ive tried unscrewing the bezel but it wont budge, is there some kind of locktite or something holding it on, my old optic T4 bezel unscrewed so i figured this one would too, and if its not possible to remove it is there any other way of removing the head from the body other than doing the freezing method? thanks, Joe

 

[GRoLED]

Yes, the head's held on with red loctite.

Check out this thread http://www.candlepowerforums.com/vb/showthread.php?t=172104 over in Homemade and Modified for more information.

Good luck with your modding.