I recently purchase an Invoa X1 (the newer series with the clear lens) and have noticed that the rubber momentary on/off switch on the end of the tailcap is not very effective. It seems like you have to have the twistie tail-cap set to where it's almost in an "on" position and that it takes an awful lot of thumb pressure to activate it. I've noticed that if just press down the whole tail cap that it seems to work a little better but still get some flickering from poor contact unless the twisty is set only about a 1/8 turn from on. Do those of ya'll who have these have similar problems? If so, do you use the twistie for on/off mainly and not the momentary on button? I've cleaned the contacts and removed excess lube (in case good contact was being inhibited) but this doesn't seem to help at all. Or did I just get one with a bad switch off the shelf? Thanks...
BTW, I really like this little light...makes a good loose-inside-the-pocket EDC...I'm just a little aggravated with the switch
BTW, I really like this little light...makes a good loose-inside-the-pocket EDC...I'm just a little aggravated with the switch