kramer5150
Flashaholic
Has anyone tried it on an LED other than a Nicha?
Could doing this it smooth out Cree rings?
Could doing this it smooth out Cree rings?
LED Dome sanding or "Frosting"?
- Thread starter kramer5150
- Start date
Help Support Candle Power Flashlight Forum
LukeA
Flashlight Enthusiast
It would, but I think it would cost a lot of output.
Photon Joe
Newly Enlightened
- Joined
- Mar 5, 2006
- Messages
- 138
The best thing for cree rings I have tried is hairspray on the reflector.
Blends the rings to a uniform smooth spill.
Hold the can a couple of feet away from the reflector so that the spray can dry a little on the way and "dust" the surface when it lands.
Blends the rings to a uniform smooth spill.
Hold the can a couple of feet away from the reflector so that the spray can dry a little on the way and "dust" the surface when it lands.
Yes, thats not a good way in my opinion, better take an OP Reflector when you can.
There was a thread in the General forum recently on frosting lenses (rather than the dome). Perhaps similar enough to give you some ideas, or an alternative approach.
http://www.candlepowerforums.com/vb/showthread.php?p=2670093
http://www.candlepowerforums.com/vb/showthread.php?p=2670093
TONY M
Flashlight Enthusiast
Do not touch the cree dome as it can become dislodged easily - effectively destroying it.
