LED Failure

TigerhawkT3

Flashlight Enthusiast
Joined
Jul 2, 2006
Messages
3,819
Location
CA, 94087
Chip weevils?! you must be joking, right?
Please tell me that you're joking! :eek:
Yes. The above-linked Wiki entry refers to 5mm LEDs and now Luxeons getting dimmer and needing to be replaced, but it's because of brighter and more efficient emitters, like the XR-E. Granted, LEDs do degrade (especially non-high power ones), but that's largely due to heat damage.

Once more: "chip weevils" are a joke. You can laugh now. :)
 

yellow

Flashlight Enthusiast
Joined
Oct 31, 2002
Messages
4,635
Location
Baden.at
The time when modding was usual because there were no decent makers (say: 2 years plus ago, just be4 Fenix entered), led failures happened often.

Take a white power-Led, reverse its polartiy and it immediately dies, even with the "right" voltage, no matter if direct driven or when just reversing the contacts from a driver cirtuit.
immediately and ultimatively

... and so do most drivers (sure, some might be protected, but better just not to do)
(also quite a bunch of drivers die, when power is applied without led connected. So be careful when modding)


other failure: quick led degration from bad heatsinking
 

richardcpf

Flashlight Enthusiast
Joined
May 23, 2008
Messages
1,281
Normally led wont fail if driven at correct V and A, in most cases is the driver which fails.
 

Jarl

Flashlight Enthusiast
Joined
Jan 11, 2007
Messages
1,745
Location
Southern UK
Take a white power-Led, reverse its polartiy and it immediately dies, even with the "right" voltage, no matter if direct driven or when just reversing the contacts from a driver cirtuit.
immediately and ultimatively

... and so do most drivers (sure, some might be protected, but better just not to do)
(also quite a bunch of drivers die, when power is applied without led connected. So be careful when modding)

Not true. Less than 5V and the LED is fine. It's a light emitting DIODE. Resitance in the light emitting direction is very low (~4 ohms, though resistance increases as current decreases). Resistance in the not-light emitting direction is very high, blocking any current. However, if the voltage is too high then it'll short the LED and destroy it.



Dont forget sharkbite, bear attack or children under 5

ROFL :devil:
 
Top