DVH8
Newly Enlightened
Preliminary inquiry:
I am designing some electronics which will use a Convoy L2 host as its power supply and battery holder.
I will need a forward enclosure (Aluminum?) that will replace the front lens retaining ring, and needs to be threaded to match the host.
I don't have a complete design yet, so for now assume the OS and ID to match the host, and the length of this section is not more than 2 inches.
The front end will need some sort of closure with a 12mm hole, and that cap may need to be plastic rather than metal.
I have no idea what the thread metrics are, and MTNElectronics doesn't either.
I would like to get them anodized to match the host, and some "tacticool" machining features would be nice as long as it doesn't drive up the cost too much.
I'd like to find someone who can work with me as I refine my requirements, and in the end produce 100 of these enclosures.
I'm not equipped with solidworks, but I can develop the overall shape in OpenSCAD if that helps.
I am designing some electronics which will use a Convoy L2 host as its power supply and battery holder.
I will need a forward enclosure (Aluminum?) that will replace the front lens retaining ring, and needs to be threaded to match the host.
I don't have a complete design yet, so for now assume the OS and ID to match the host, and the length of this section is not more than 2 inches.
The front end will need some sort of closure with a 12mm hole, and that cap may need to be plastic rather than metal.
I have no idea what the thread metrics are, and MTNElectronics doesn't either.
I would like to get them anodized to match the host, and some "tacticool" machining features would be nice as long as it doesn't drive up the cost too much.
I'd like to find someone who can work with me as I refine my requirements, and in the end produce 100 of these enclosures.
I'm not equipped with solidworks, but I can develop the overall shape in OpenSCAD if that helps.