Z
z_campasino
Guest
hi
i was planing to power my maxflex and leds from a new lipo battery .the wire on the lipo is about 3.5 mm diameter and doesnt fit the terminals of the connectors that i was going to use.is it ok to put this thick wire into a terminal block, with thin wire the other side that is small enough to solder to the maxflex?.
i havent read of anyone else doing this ,so what do others do, use a connector with very different wire sises on each side?
if not how do i get round this problem please, and sorry if im being thick, im new to all this.
thanks
i was planing to power my maxflex and leds from a new lipo battery .the wire on the lipo is about 3.5 mm diameter and doesnt fit the terminals of the connectors that i was going to use.is it ok to put this thick wire into a terminal block, with thin wire the other side that is small enough to solder to the maxflex?.
i havent read of anyone else doing this ,so what do others do, use a connector with very different wire sises on each side?
if not how do i get round this problem please, and sorry if im being thick, im new to all this.
thanks
