modify mce series start to parallel?

[ifor powell]

I have a MCE on a series star from cutters but have decided I need parallel rather than series. Looking at things there are three tracks I need to cut two are well clear of the led and I should be able to cut no trouble. The third is right next to the led and I am not sure if it extends underneath it or not so it is not clear if I can easaly cut it. Has anyone done this? Soldering up to get the leds parallel should be easy if I can get the tracks cut.

Ifor

 

[ledstein]

Do you have any diagram of the star circuit?
Why dont you cutters (a website?)? They should know what they are selling...

 

[yellow]

there must be three connections, all of them have to be cut.
Then solder each side together
done


in series means less current means smaller drivers
(+ there are drivers available already. Good, tested and proven for years)