Need diameter of Dereelight CL1H reflector

[rayman]

I want to mod my JETBeam Jet-III Pro with a XP-G. So I was looking for a fitting reflector. The Dereelight CL1H V4 and the Jet-III Pro have about the same head diameter so the reflector might fit with some modification. The reflector of the Jet-III Pro has a height of 22m and a diameter of 22,65mm. So can anybody please measure the reflector of their CL1H and give me the height and the diameter?

Thanks,
rayman

 

[Gryffin]

The CL1H is a "D26 host", meaning it uses any Surefire-compatible D26-type drop-in (drop-in = assembly consisting of reflector, emitter, driver, heatsink "pill" and contact springs). D26 reflectors are 26mm in diameter (hence the name); length can vary by a few mm.

 

[dhouseng]

i modded my jetbeam jet-ii IBS (which has the exact same reflector with jet-iii pro) to XPG R5 without changing the stock reflector, the beam is as good as (or better than) the CL1H reflectors.

 

[rayman]

Sounds good. Did you still use the centering ring and what size was your emitter board?

rayman

 

[dhouseng]

Sounds good. Did you still use the centering ring and what size was your emitter board?

rayman

nope the centering ring is too thick, i changed to a thinner paper insulator so i can screw the bezel all the way down to make the beam more efficient.
i used the 14mm base XP-G R5 emitter from ebay.

after i swapped the emitter from Q5 to R5, the current draw becomes 1.92A at 100%, i dont know why. it gets quite warm after only 15 seconds, so i set it to 50% max now.