I was getting no love for my question in the main EZ thread so figured I would start a new one. I haven't seen any other post with a similar issue.
I received 2 EZ123w today from 4Sevens. Very nice lights. I purchased one for me and one for a friend. Being a good friend and all I had to make sure that they both worked. While checking them side by side I noticed that one of them was much brighter than the other on low. The lowest one is about the same brightness as my EX10 about 3 lumens or so. The brighter of the 2 is about 2 to 3 times brighter than that I would say the 10 lumens it is rated for. On high they are both very close in brightness. Is there a problem in the circuit in the dimmer one or is it just luck of the draw. The current measured by my DMM on the dimmer one is .018A and on the brighter one is .078A. To me I like the lower low so am inclined to keep it but if there is a circuit problem that will later render the light unusable I would like to get it fixed. Any insight greatly appreciated and anyone with a similar condition. Thanks in advance.
I received 2 EZ123w today from 4Sevens. Very nice lights. I purchased one for me and one for a friend. Being a good friend and all I had to make sure that they both worked. While checking them side by side I noticed that one of them was much brighter than the other on low. The lowest one is about the same brightness as my EX10 about 3 lumens or so. The brighter of the 2 is about 2 to 3 times brighter than that I would say the 10 lumens it is rated for. On high they are both very close in brightness. Is there a problem in the circuit in the dimmer one or is it just luck of the draw. The current measured by my DMM on the dimmer one is .018A and on the brighter one is .078A. To me I like the lower low so am inclined to keep it but if there is a circuit problem that will later render the light unusable I would like to get it fixed. Any insight greatly appreciated and anyone with a similar condition. Thanks in advance.
