chrisWELD
Newly Enlightened
Hello all,
trying to get my M3 (with cren bezel) to work on 2 Pila 150S but no joy - 4-5mm longer than 3x123. The Pila's appear to have come charged, as charger went from red to green within a couple of mins.
I was shipped a couple of springs too, but not sure what to do with them - am I supposed to replace the springs on the lamp assemblies (mn10/11)?
I've also tried just dropping the spring in the bezel end of the body and screwing the bezel back on both fully and loosening it a bit but apart from a brief burst of light, a couple of times, nothing...
I also read on the "Pila for newbies" thread that some have had to loosen the bezel also?
Thanks in advance for any tips!
Chris
trying to get my M3 (with cren bezel) to work on 2 Pila 150S but no joy - 4-5mm longer than 3x123. The Pila's appear to have come charged, as charger went from red to green within a couple of mins.
I was shipped a couple of springs too, but not sure what to do with them - am I supposed to replace the springs on the lamp assemblies (mn10/11)?
I've also tried just dropping the spring in the bezel end of the body and screwing the bezel back on both fully and loosening it a bit but apart from a brief burst of light, a couple of times, nothing...
I also read on the "Pila for newbies" thread that some have had to loosen the bezel also?
Thanks in advance for any tips!
Chris
