replacement driver 3V

[Nico87]

Hi

First of all, please forgive me, if my english is not that good. My english is not the best, but i think, you'll understand what i mean.

So what happend?

I don't exactly kow haw, but i managed to blew out the driver of my L1T 2.0 by installing a Rebel 100 LED.
My L1T is working on aP2D body with a 123pirimary (2,85 V left) If i turn it on in low mode, the Led dosn't lite up. Ther is 2V between the connetin wires, 0.3 from Neg to groung and 2,3 V from pos to ground (body). In high mode, the Led gives a very lite light. Ther's no Voltage between neg and the body, and 2,3V from pos to neg/body.

The LED is still working on 3V DD
I think the driver is dead.

So i need a new driver.
I´d like to have 2 Modes, with a low setting, and a high with 800-1000mA current. 3 modes would be ok. I know, that I won't be able to swich between the modes by turning the brezel. Thats fine. I'd like to use the Rebel that i have.
If there is no 2/3 mode driver that would fit into the L1T, a 1mode would be ok...but just if ther's no other way.

Hope that you can help me

Nico

...ah...if there are big misstakes, please show them to me...or i'll write like this for ever...

 

[Nico87]

come on guys...why does nobody answer??

 

[Doh!Nut]

Hi Nico

The only person who makes drivers likely to fit in a Fenix head is the Sandwich Shoppe.
The BBNextgen is 0.55" or 14mm diameter
this should boost ~3v to Led Vf

Nick

 

[Nico87]

Thanks...I already looked at all the boards at the Sandwich Shoppe, but there's no 2 Mode Driver...The only thing that could work, is the shark driver with Remora UI...just dont know, if this would fit...

Nico

 

[Nico87]

Is nobody here who knows another possibility?