Strange behaviour in Ti Quark

[bernards]

I have a lego Ti quark regular /w clip that behaves a little strange. The blinking modes, (noticeable in the SOS and beacon modes) it doesn't go off-on-off-on-off-on, etc. Instead it goes moon-on-moon-on-moon-on. I checked my Al XP-G and Q3, both are off-on-off-on.

Anybody else have their quark behave this way?

 

[Haz]

My 2x Quark Ti (serial one) behaves normally, i don't think I have experience anything like you before.

 

[chaosmagnet]

I have a lego Ti quark regular /w clip that behaves a little strange. The blinking modes, (noticeable in the SOS and beacon modes) it doesn't go off-on-off-on-off-on, etc. Instead it goes moon-on-moon-on-moon-on. I checked my Al XP-G and Q3, both are off-on-off-on.

Anybody else have their quark behave this way?

I own three Quarks and they all behave the same way.

In beacon mode, it will ramp up to full brightness and ramp down again. Personally, I would prefer that it just turn on at full brightness and turn off again, but this behavior is normal.

In SOS mode, it should be flashing at full brightness. If yours doesn't, I'd suggest you send it back for warranty service.