I have been looking at the T1A as an EDC light for some time and I just can't get use to the idea of something with out a clip. I figured with all of the creative abilities that lie in the CPF some one could machine a tail that would accept a a clip.
While I don't have the machining skills to do such a thing I wanted to put this idea out there and see if the skilled people of the CPF could make a run of these.
The thinking was to make a tail cap that would screw on to the T1A as the stock one did but then to have an additional ~1/4 of material let on top of the threaded portion. That section could then be drilled and tapped to accept some type of generic pocket clip. Something like the Bitz clip.
I am throwing this idea out there, I hope this sparks interest and some one can run with it to make a batch of pocket clip accepting tail caps for the T1A.
While I don't have the machining skills to do such a thing I wanted to put this idea out there and see if the skilled people of the CPF could make a run of these.
The thinking was to make a tail cap that would screw on to the T1A as the stock one did but then to have an additional ~1/4 of material let on top of the threaded portion. That section could then be drilled and tapped to accept some type of generic pocket clip. Something like the Bitz clip.
I am throwing this idea out there, I hope this sparks interest and some one can run with it to make a batch of pocket clip accepting tail caps for the T1A.
