Tritium P2D

[scottaw]

I was wondering if anyone has done it yet, or if it would be possible to cut grooves in a P2D body for some trits. The smaller flat spots on the battery tube seem like a nice place if there is enough metal there. Maybe even around the tailcap. Anyone up for it?

I posted this under general and nobody is responding, thought this might be more appropriate. Admins, delete either post which you fell is inappropriate.

 

[Morelite]

Scott,
Most likely the flats are going to be too thin to mill out a 1.5+mm deep slot. I don't have a P2D to look at but I live a couple miles from State College and I can meet you to take a look. If it looks possible, I have a mill and will be more than willing to do the work.

Dwayne

 

[MorpheusT1]

LOL.

I thought i read Titanium P2D.


Now that would be something though...
I really like the UI of the P2D,mate that with a McClicky and the P2D style body.

Yummy...



Sorry for the hijack,my mind just wandered away.



Benny

 

[greenLED]

You could put them around the tailcap with some epoxy.

 

[scottaw]

Where around the tailcap? Are there ones that could flex to fit around the switch? Or do you mean mill out some of the tailcap?

 

[MorpheusT1]

If you buy the small Tritiums from bart i think you can fit 3-4 tritiums around the rubber button inside the cavity of the tailcap.

Tritiums are not flexible,since they are made of glass.


If you dont already know this,Green are brightest.


Benny