What size GITD o-ring for Fenix L1D and L2D?

[_Shawn_]

I'm planning on adding a glow in the dark o-rings to a L1D. One GITD o-ring will replace the current o-ring the bezel next to the lens, and one between the body and tail cap.

I remember reading a post long ago that had the information in it but have not been able to find it when searching.

What size do I need for the o-ring in the bezel?

Thanks!


edit: I think i should have posted in the 'Homemade and Modified lights' section. How do i move it to that section?

 

[R-R]

I had the same question... So I'll bump this up ;-)

 

[thezman]

Most of the GITD o-rings that I've handled are too thick to work in the lens/bezel area of the Fenix lights. There may be some out there that do work, but I haven't found them yet.

 

[greenLED]

7/16" or the 0g should work (if you stretch it carefully over the light - it'll be tight).