-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
WTB - P60 drop-in for Surefire 9P Single Mode
- Thread starter F250XLT
- Start date
Help Support Candle Power Flashlight Forum
thermal guy
Flashaholic
Re: WTB - P60 drop-in for Surefire 9P
I have a lot of Dropins but not a single one that is multi mode and up to 9 volts. Lumens factory might have something you can use.
I have a lot of Dropins but not a single one that is multi mode and up to 9 volts. Lumens factory might have something you can use.
thermal guy
Flashaholic
Re: WTB - P60 drop-in for Surefire 9P
😂😂 kinda got me on that👍🏻
😂😂 kinda got me on that👍🏻
thermal guy
Flashaholic
Re: WTB - P60 drop-in for Surefire 9P
Does it have to run on 3 primaries? Would say a 16650 and dummy spacer in you 9P work for you? Or 2X1700?
Does it have to run on 3 primaries? Would say a 16650 and dummy spacer in you 9P work for you? Or 2X1700?
Re: WTB - P60 drop-in for Surefire 9P
Just like the option to run on 3 primaries for the runtime.
Just like the option to run on 3 primaries for the runtime.
- Joined
- Feb 2, 2006
- Messages
- 1,154
Re: WTB - P60 drop-in for Surefire 9P
LF modules with buck driver have a wide VIn range (3.6-13V). Not sure if their three-mode (H/M/L) variants have the same driver though...
Multimode is convenient, but on typical SF 6P/9P setups with forward clicky (eg. Z41 McClicky mod) setup it's not. With such body host setups I always have single-mode modules only for simplicity, as well as Morse code capability.
LF modules with buck driver have a wide VIn range (3.6-13V). Not sure if their three-mode (H/M/L) variants have the same driver though...
Re: WTB - P60 drop-in for Surefire 9P
I have a Malkoff M91 AW if you are interested.
I have a Malkoff M91 AW if you are interested.
