Englishbob
Newly Enlightened
Hello chaps
Just thoght i'd ask the question in case any of you guys know the answer- I have a Gladius which I find superb and the torch that does pretty much everything I need it to do until the other night when I was up on top of a distallation tower 250ft up when my torch decided to fail to switch from low setting to high. The plastic bezal moves no problem and the low light came on but when moved round to full on setting it failed to illuminate. This has happened before but never when I really needed it!!!
It would appear that the only way to get it working again is to turn it off and take off the end cap for 10 seconds then replace and works fine until next time!! Any ideas?
Have contacted via e-mail the chaps at Blackhawk - very quick to respond which I was impressed with - they said they would send a new tail cap no questions!! Good service I think:goodjob:
What do you think could cause the problem, anybody else have this problem and if so did the new tail cap fix it?
Cheers all
Mark
Just thoght i'd ask the question in case any of you guys know the answer- I have a Gladius which I find superb and the torch that does pretty much everything I need it to do until the other night when I was up on top of a distallation tower 250ft up when my torch decided to fail to switch from low setting to high. The plastic bezal moves no problem and the low light came on but when moved round to full on setting it failed to illuminate. This has happened before but never when I really needed it!!!
It would appear that the only way to get it working again is to turn it off and take off the end cap for 10 seconds then replace and works fine until next time!! Any ideas?
Have contacted via e-mail the chaps at Blackhawk - very quick to respond which I was impressed with - they said they would send a new tail cap no questions!! Good service I think:goodjob:
What do you think could cause the problem, anybody else have this problem and if so did the new tail cap fix it?
Cheers all
Mark
