Bmccue1964
Newly Enlightened
Based upon prior postings, I took an old 9 volt battery and removed the clip portion. I then soldered in a 270 ohm resistor and 1 single white LED to the connections. The whole works were then potted in epoxy. The light puts out enough light for close up reading and also enough light to "bump proof" an average sized room in the dark. Provides enough light in a bathroom to enable "functions".
As of 8:30am this morning, the light has been running for 2 WEEKS without any noticeable decrease in output (new 9volt alky battery at start).
Simple to make and very useful in an emergency.
As of 8:30am this morning, the light has been running for 2 WEEKS without any noticeable decrease in output (new 9volt alky battery at start).
Simple to make and very useful in an emergency.