AaronM
Enlightened
I just fully stripped an old KL4 head, ordered a SSC emitter, heat conducting goo and epoxy.
Now I need to know some details:
If I need to spacer the emitter what thickness & material do I use?
What wire should I use? (the insulation can't be too thick 'cause the wire has to pass through small holes to get from the driver board to the emitter)
Any other things that need custom attention?
Thanks
Now I need to know some details:
If I need to spacer the emitter what thickness & material do I use?
What wire should I use? (the insulation can't be too thick 'cause the wire has to pass through small holes to get from the driver board to the emitter)
Any other things that need custom attention?
Thanks